Chuck size sets the largest shank the drill will take, and it is the number to start from. The range here runs 6.5mm on the mini bodies up to 13mm, with drive size stated on 63 of the 69 lines and chuck size on the rest. A drill that will not close on the bit is no use whatever else it does.
Keyed or keyless is the next decision and it is about how often the bit changes. A keyless chuck is quicker and needs no key to lose, a keyed chuck grips harder on a bit that is being pushed. Both are held across the range, and the listing says which a drill carries rather than leaving it to the photograph.
Reversible or not decides whether the drill will back a bit out of a bind or drive a fastener as well as drill. Non-reversible bodies are simpler and often lighter. Body form then decides access: straight bodies for open work, pistol grip for control under load, and angle bodies for a hole that cannot be approached square.
Some CP1114 lines carry ATEX variants for work where an electric drill cannot be used at all, which is one of the reasons an air drill still earns its place in a bay that has mains power everywhere else. Free speed is stated on 62 of the lines. A photo of the space the drill has to work in, sent over WhatsApp on 07754288583, settles the body form question quickly. Body forms run straight, pistol and angle across the PCL APT and APM ranges and the Sealey Generation bodies, so the same chuck size can be had in three shapes.
Filters
Cart
POPULAR CATEGORY
