Filters
Setting out splits between holding a line and marking one. A ranging line is pulled between two points and stays there while work happens against it. A chalk line snaps a mark onto the surface and is then wound back in, leaving the line behind rather than the string. Using one where the other belongs is the common error and it shows up as work built to a line nobody can see.
That difference decides which tool the job needs. A wall built to a line uses a ranging line. A cut marked across a floor or a sheet uses a chalk line, because nobody can work with a string in the way of the saw. A chalk line also marks a surface that is already fixed, where a ranging line guides work still being built.
Line length runs 30m and 100m at 2.5mm diameter. Diameter matters on a ranging line because a thin line sags less over a long span for the same tension, and sag is what puts the middle of a run out. A 100m ranging line covers a site frontage where a 30m line has to be moved along it.
A self-chalking line reloads itself as it is wound in rather than needing chalk poured in each time, which matters where many lines are snapped in a day. A measuring wheel covers distances too long to tape. Send the setting out job to 07754288583 on WhatsApp. A chalk line set at 30m arrives with the chalk rather than needing it ordered separately.
By sharing your email, you agree to our privacy policy & terms of service
Cart
POPULAR CATEGORY
