Filters
This leaf is weighted to commercial vehicles, and that changes where the selection starts. An HGV hub puller and a car hub puller are not the same tool at different sizes, because the forces, the thread sizes and the access are all different. Vehicle class comes before the job.
Hub and shaft extraction is the heaviest work here. An adjustable hub puller adapts to different stud patterns rather than being cut to one, and an axle half-shaft puller draws a shaft that a hammer will not move. An axle spindle rethreading kit at 9 pieces repairs the thread once the nut has damaged it. Sykes and Laser hold most of this range, which is where commercial vehicle tooling tends to sit.
Ball joint removal on a truck uses a different scale of tool again, at 30mm and 39mm, with a separator listed for the Volvo FM12. A pitman arm puller at 58mm covers Scania and DAF steering arms, which are pressed on and will not come off any other way. The car tooling on the leaf is thinner by comparison and covers tie rods, arms and driveshafts rather than hubs.
Brake work on trucks brings its own kit, with a 2 piece air brake adjusting kit, exhaust brake adjustment gauges for Volvo and Mack and a brake pad thickness gauge. Car suspension tools sit alongside, including a driveshaft extractor fork at 390mm. Send the vehicle and the job to 07754288583 on WhatsApp. A suspension arm lever is held alongside for levering an arm into position during reassembly.
.jpg?v=1785491361)
By sharing your email, you agree to our privacy policy & terms of service
Cart
POPULAR CATEGORY
