Loppers by Cutting Action, Handle Type & Length

Shop by Sub Category

Length (mm)

685 (6370f5616c5fd4f190000b3d)
750 (6370f5616c5fd4f190000b3d)

FAQs

Bypass blades pass each other like scissors and cut cleanly, which living wood needs to heal. An anvil blade crushes the stem against a flat face, which is faster on dead wood but damages green growth.

Takes the cut in stages rather than one squeeze, so a thick branch can be worked through without needing the hand strength to do it in a single movement.

It multiplies the force applied at the handles rather than dividing the cut into stages. Both make a thick cut easier; the ratchet does it in steps and the gear does it continuously.

685mm on the standard loppers gives reach and leverage for most work. The 750mm ratchet forms add both. Telescopic handles extend beyond that for reaching into a canopy from the ground.

Aluminium keeps the tool light for overhead work. Steel is stiffer and heavier, which suits the ratchet and telescopic forms where the load through the handle is higher.

A three piece lopper, shears and secateur set covers the cutting range in one purchase, which suits a garden being equipped rather than a specific cut being made.

Clear

Bypass and anvil are the first choice and they leave different cuts. Bypass blades pass each other like scissors and cut cleanly, which is what living wood needs to heal. An anvil blade crushes the stem against a flat face, which is faster on dead wood and damaging on green growth. The blade type is worth deciding before the handle, since it is the part that cannot be changed afterwards.

Cutting action then decides how much force the user has to supply. A plain lopper is a single squeeze. A ratchet action takes the cut in stages so a thick branch can be worked through without one hard squeeze. A gear action multiplies the force applied instead.

Handle length gives both reach and leverage, at 685mm on the standard loppers and 750mm on the ratchet forms. Telescopic handles extend beyond that, which reaches into a canopy from the ground without needing a pole pruner. Aluminium handled bypass and anvil loppers are both held at 685mm, so the action is chosen without changing the reach.

Handle material is a weight and stiffness trade. Aluminium keeps the tool light for overhead work. Steel is stiffer and heavier, which suits the ratchet and telescopic forms where the load is higher. A three piece lopper, shear and secateur set covers the range. Send the growth type to 07754288583 on WhatsApp. Gear action soft grip anvil loppers sit alongside the ratchet forms at the same handle length.