Carpenters Chisels by Blade Width, Type & Handle

Shop by Sub Category

Type

Carpenters Chisel

FAQs

By the joint rather than the timber. A mortice is cut with a chisel matching its width; a narrower chisel leaves a stepped side that has to be pared back afterwards.

One ground away at the sides so it reaches into an acute corner, which a firmer chisel with square sides cannot. That is the general carpentry pattern.

The steel runs from the blade through the handle to a striking cap. That lets the chisel take a mallet repeatedly where a tang handle eventually splits at the shoulder.

6, 10, 13, 16, 19, 22 and 25mm at 140mm, which covers the common mortice and paring widths without gaps in the ladder.

With a honing guide, which holds the blade at a consistent angle on the stone. Sharpening freehand changes the angle each time, which is what shortens a chisel's life.

The guide here holds 3 to 67mm, which covers chisels and plane irons rather than only the narrower blades.

Clear

Blade width follows the joint rather than the timber. A mortice is cut with a chisel matching its width so the walls stay parallel, and a chisel narrower than the mortice leaves a stepped side that has to be pared back afterwards. Width is stamped on the blade, so the chisel is matched to the joint rather than estimated against it.

A bevel edge blade is ground away at the sides so it reaches into an acute corner, which a firmer chisel with square sides cannot. That is what makes bevel edge the general carpentry pattern rather than a lighter version of the same tool. A square edged blade is still held for firmer work where the sides do not need to be reached past.

Pound thru construction runs the steel from the blade through the handle to a striking cap at the end. That is what lets the chisel take a mallet repeatedly, where a tang handle eventually splits at the shoulder however carefully it is struck. A striking cap also shows wear before the handle fails, which a tang handle does not.

The edge is what does the work and it dulls with use rather than failing. A honing guide holding 3 to 67mm sets a consistent angle on the stone, which is what keeps a chisel cutting rather than being sharpened differently each time. Send the joint to 07754288583 on WhatsApp. Soft grip handles are held across the full width ladder rather than only the larger blades.