Draper Carbon Brushes, Armatures & Switches by Code

find the right

Spares/ Consumables/ Accessory

Shop by Sub Category

Capacity

2.0Ah (Kg)
3.0Ah (Kg)
4.0Ah (Kg)
5.0Ah (Kg)

By parts list code from the tool's manual, or the Stock Number and a photo over WhatsApp: brushes, switches and armatures are coded to their tools, and the drop down selector shows a tool's parts in one view.

Carbon brushes, almost always: worn brushes spark at the vents, surge and drop power, and they are the cheapest coded part on the shelf, sold singly, in pairs and as assemblies with holders.

By behaviour and length: sparking, surging and cutting out are the signs, and brushes worn near their spring stops are done, replaced in pairs so the motor wears evenly.

The switch: coded switches are the second commonest cure, and only after brushes and switch does the armature, the dear rotating heart, enter the diagnosis.

Coded by tool: chucks with keys for the drills, the half inch collet, and backing pads named for their sanders, the PT241SF pad among them.

The shelf's arithmetic says yes: brushes cost pennies against a tool, a switch little more, and even an armature is a fraction of replacement, each one coded so the repair is exact.

Clear

Six hundred coded parts serve the Draper power tool ranges, and one part rules the shelf: the carbon brush. Brushes wear with every hour a motor runs, and they sit here singly, in pairs, as complete assemblies and with their holders, each coded to its tools, because a power tool that sparks at the vents, surges under load, or cuts out mid job is asking for its brushes long before anything else is to blame.

The diagnosis order the trade itself uses prices the shelf. Brushes first, the cheapest and commonest cure by far. The switch second where the tool is dead or intermittent rather than sparking, coded switches sitting here in real quantity. The armature last, the motor's rotating heart, dearer but still a coded part rather than a new tool, with main gears, end plates and stop plates rebuilding the drive train around it piece by piece.

The business ends are coded too: chucks complete with their keys for the drills, collets in the half inch form for the routers and grinders, and backing pads named for their sanders, the PT241SF pad among them, so the working face of a tool renews as it wears rather than deciding its fate.

The method is the Draper estate's: the parts list code from the manual typed into search, or the Stock Number and a photo over WhatsApp on 07754288583 where the manual has gone, with the drop down selector showing a tool's coded parts complete in one view and the Compatible tab confirming each match from the part side. A tool worth its cord is worth its brushes, and this shelf of six hundred coded lines is built on exactly that arithmetic.